Intro to Fabrication

I didn’t start out with a plan. First I did a test cut. I calculated how to compensate for kerf in the finger sizes, and came up with this design: I tried to engrave a picture of my girlfriend’s dog…

This week’s assignment in Introduction to Fabrication was to make five identical objects using the techniques we’ve covered so far. I made five Bowtie Things with Holes: I used the miter saw to cut a long board into five equal-sized…

I made this box: I used a 2×4 from the scrap bin. It was too long, about a foot, so I used the compound miter saw to cut it down to about 4 inches. Then I used the band saw…